I got an apadravya piercing months and months ago.  It was pierced at 10g, and the bar was custom made.  I told the piercer that i think its too tight but she kept saying its fine.. well now, it's not healing properly.  I have a dent in my dick.

here's a picture of the hole..



sometimes, the dent is deeper then other times (usually after sex, masturbating, etc.) but there is always a dent present. 
I don't know what to do...

will this heal properly?  

I thought about switching the ball to a flat disc but I called all the local shops nearby and they don't sell flat discs.  =[
most shops don't carry 10g jewelry at all here.. (which is why it's difficult getting a bigger barbell)

I looked online on a lot of sites and cannot find a barbell that's around 1 1/4'' (30-32mm) that is sold with flat discs.   In fact, finding flat discs that fit on 10g jewelry is very difficult.. (all i could find was anchor heads for dermals and they're only good for 14-12g jewelry.. )

You should get a bar that's a little longer. After doing so, the sinking and the "extra" circle skin/scarring you're experiencing should clear up within a few days to a few weeks. :)

Also, have you looked into dome shaped tops for your barbell?


Edited by Cale - June/29/2011 at 2:48am

Which websites have you checked? I am sure some people here can recommend good sites to use.

try the M&M shaped ends from anatometal.

thank you again for your replies =) I appreciate it
I regularly shop from painfulpleasures, piercedfish and mspiercing for my piercings

if 316L ASTM F-138 Stainless Steel is suitable material, I can get my hands on that one fast (the one from painfulpleasures)

I prefer flat discs over domes, I'll order them soon
thank you again =)

I'm relieved the scar tissue will go away when I switch bars